Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015213 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  CHECK MODE PROCEDURE  


NOTICE:

Enter "Signal Check" from the "DTC Check" screen displayed on the intelligent tester or Techstream to clear the output DTCs (both present and past).


HINT:
·

DTCs can be stored more sensitively in check mode than in normal diagnosis mode.

·

Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.



CHECK MODE PROCEDURE (Using the Intelligent Tester or Techstream)


a.

Turn the ignition switch off.


b.

Connect the intelligent tester or Techstream to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the intelligent tester or Techstream on.


e.

Select "Signal Check" and proceed with checking using the intelligent tester or Techstream.