Home › Vehicle Interior › SEAT › REAR NO. 1 SEAT ASSEMBLY › 2011.11–2013.07
RM19Y0E _58 Vehicle Interior _003011 SEAT _0015215 REAR NO. 1 SEAT ASSEMBLY A

SEAT  REAR NO. 1 SEAT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

The procedure described below is for RH side. Use the same procedure for both RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 72607 1.INSTALL REAR SEAT CUSHION LOCK STRIKER

a.

Install the rear seat cushion lock striker with the nut and bolt .

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


Hide 2.INSTALL REAR NO. 1 SEAT ASSEMBLY

a.

Place the rear No. 1 seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

Temporarily install the rear No. 1 seat assembly with the 4 bolts.


c.
B292421
0.552,3.125 0.917,3.427 0.365,0.302 10 1 2.292,2.146 2.667,2.531 0.375,0.385 10 3 2.667,2.417 3.115,2.792 0.448,0.375 10 4 0.052,2.885 0.438,3.229 0.385,0.344 10 2

Tighten the 4 bolts in the sequence shown in the illustration.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 71485 3.INSTALL REAR SEAT HINGE COVER

a.

Attach the 4 claws and install the 2 rear seat hinge covers.