Wear protective gloves. Sharp surfaces on the rear seat back frame sub-assembly and rear seat cushion frame sub-assembly could cause injuries to your hands.
The procedure described below is for RH side. Use the same procedure for both RH and LH sides, unless otherwise specified.
72637A
1.REMOVE REAR SEAT LOCK HANDLE
| *1 | Protective Tape |
| *2 | Snap Ring |
Using a screwdriver with its tip wrapped in protective tape, pull out the snap ring and remove the rear seat lock handle.
71833A
2.REMOVE REAR NO. 1 SEAT RECLINING COVER
Remove the screw.
Disengage the 2 claws and remove the rear No. 1 seat reclining cover.
79011
3.REMOVE NO. 1 SEAT CUSHION COVER SUB-ASSEMBLY
Remove the 2 screws.
Disengage the 4 claws and remove the No. 1 seat cushion cover sub-assembly.
71878A
4.REMOVE REAR SEAT INNER RECLINING COVER
Disengage the claw and remove the rear seat inner reclining cover.
5.REMOVE REAR NO. 1 SEAT BACK ASSEMBLY
| *1 | E Ring |
| *2 | Bushing |
Remove the 2 bolts, E ring and rear No. 1 seat back assembly.
Remove the bushing.
71970
6.REMOVE REAR SEAT HEADREST ASSEMBLY
| *1 | Lock Button |
Push in the lock button of the rear seat headrest support assembly and remove the rear seat headrest assembly.
71931A
7.REMOVE REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY
Detach the hook.
Remove the 3 hog rings.
Detach the 2 claws and remove the rear No. 1 seat headrest support assembly.
71931B
8.REMOVE REAR NO. 1 SEAT HEADREST SUPPORT
Detach the 2 claws and remove the rear No. 1 seat headrest support.
71077S
9.REMOVE SEPARATE TYPE REAR SEAT BACK COVER
Remove the 3 hog rings and the separate type rear seat back cover from the separate type rear seat back pad.
71651S
10.REMOVE SEPARATE TYPE REAR SEAT BACK PAD
Remove the separate type rear seat back pad from the rear seat back frame sub-assembly.
71671
11.REMOVE REAR SEAT BACK SILENCER PAD
Remove the rear seat back silencer pad from separate type rear seat back pad.
72159A
12.REMOVE REAR SEAT TRACK BRACKET COVER (for Slide Seat Type)
Detach the 4 claws and remove the 2 rear seat track bracket covers.
13.REMOVE REAR SEAT LEG COVER (for Slide Seat Type)
Remove the screw, rear seat cushion and rear seat leg cover.
71324A
14.REMOVE REAR SEAT CUSHION (for Non-slide Seat Type)
Remove the screw and rear seat cushion.
72694
15.REMOVE REAR SEAT CUSHION LOCK COVER (for Slide Seat Type)
Remove the 2 screws and rear seat cushion lock cover.
72694
16.REMOVE REAR SEAT CUSHION LOCK COVER (for Non-slide Seat Type)
Remove the 2 screws and rear seat cushion lock cover.
73330
17.REMOVE REAR SEAT LAP TYPE BELT ASSEMBLY
72670B
18.REMOVE REAR SEAT CUSHION LOCK ASSEMBLY (for Slide Seat Type)
| *1 | Rear Seat Lock Control Cable |
Disengage the clamp and disconnect the rear seat lock control cable.
Remove the 2 bolts and rear seat cushion lock assembly.
72670B
19.REMOVE REAR SEAT CUSHION LOCK ASSEMBLY (for Non-slide Seat Type)
| *1 | Rear Seat Lock Control Cable |
Disengage the clamp and disconnect the rear seat lock control cable.
Remove the 2 bolts and the rear seat cushion lock assembly.
71308E
20.REMOVE REAR SEAT LEG SUB-ASSEMBLY (for Slide Seat Type)
Remove the 3 nuts and the rear seat leg sub-assembly.
72160
21.REMOVE REAR SEAT OUTER TRACK ASSEMBLY (for Slide Seat Type)
Remove the 2 bolts and the rear seat outer track assembly.
72170C
22.REMOVE REAR NO. 1 SEAT INNER TRACK ASSEMBLY (for Slide Seat Type)
Use the same procedure as for the rear seat outer track assembly.
23.REMOVE REAR NO. 1 SEAT CUSHION OUTER LEG (for Non-slide Seat Type)
| *1 | E Ring |
| *2 | Pin |
| *3 | Rear No. 1 Seat Turn Spring |
Remove the E ring and pin.
Remove the rear No. 1 seat turn spring and rear No. 1 seat cushion outer leg.
24.REMOVE REAR NO. 1 SEAT CUSHION INNER LEG (for Non-slide Seat Type)
Use the same procedure as for the rear No. 1 seat cushion outer leg.
72695A
25.REMOVE REAR SEAT LOCK CONTROL CABLE (for Slide Seat Type)
| *1 | Band |
Cut the 2 bands.
Disengage the clamp and remove the rear seat lock control cable.
72695A
26.REMOVE REAR SEAT LOCK CONTROL CABLE (for Non-slide Seat Type)
| *1 | Band |
Cut the band.
Disengage the 2 clamps and remove the rear seat lock control cable.
71075S
27.REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER
Open the fastener.
Remove the 5 hog rings.
Remove the 6 hog rings and the separate type rear seat cushion cover from the rear seat cushion pad.
71611A
28.REMOVE REAR SEAT CUSHION PAD
Remove the rear seat cushion pad from rear seat cushion frame sub-assembly.
71621A
29.REMOVE REAR SEAT CUSHION SILENCER PAD
Remove the rear seat cushion silencer pad from rear seat cushion pad.