Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003012 SEAT BELT _0015217 FRONT SEAT INNER BELT ASSEMBLY G

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 73230 1.INSPECT FRONT SEAT INNER BELT ASSEMBLY (w/ Seat Belt Warning System)

a.
B139133
0.104,0.104 0.458,0.417 0.354,0.313 10 *a
*a Component without harness connected
(Front Seat Inner Belt Assembly (for Driver Side))


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Tongue plate fastened 10 kΩ or higher
Tongue plate released Below 1 Ω


If the result is not as specified, replace the front seat inner belt assembly (for Driver Side).