Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT OUTER BELT ASSEMBLY
RM19Y0E _58 Vehicle Interior _003012 SEAT BELT _0015221 REAR NO. 1 SEAT OUTER BELT ASSEMBLY G

SEAT BELT  REAR NO. 1 SEAT OUTER BELT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 73360C 1.INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY

a.
B157634
2.104,1.792 2.208,1.948 2.208,1.948 1.594,1.802 true 2.333,0.385 2.823,0.76 0.49,0.375 10 *a 0.26,1.073 0.646,1.427 0.385,0.354 10 *b 1.156,0.271 1.542,0.656 0.385,0.385 10 *c 2.271,1.875 2.594,2.177 0.323,0.302 10 *1
*1 Retractor
*a Unlocked
*b Locked
*c 45°


Check the angle of inclination required to lock the retractor.

i.

Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.

NOTICE:

Do not disassemble the retractor.


If the result is not as specified, replace the rear No. 1 seat outer belt assembly.