88504A
1.REMOVE BLOWER CASE SUB-ASSEMBLY
Disengage the 5 claws and remove the blower case sub-assembly.
Use the same procedure for the RHD and LHD vehicle.
88550B
2.REMOVE BLOWER MOTOR ASSEMBLY
87138C
3.REMOVE BLOWER RESISTOR
88521B
4.REMOVE COOLER UNIT CASE PACKING
Remove the cooler unit case packing.
Use the same procedure for the RHD and LHD vehicle.
88515
5.REMOVE COOLER EXPANSION VALVE
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and detach the cooler expansion valve.
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
Use the same procedure for the RHD and LHD vehicle.
88539J
6.REMOVE DRAIN COOLER HOSE
Remove the drain cooler hose.
Use the same procedure for the RHD and LHD vehicle.
88304A
7.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY (for RHD)
w/o Heater:
Disengage the No. 1 cooler thermistor connector clamp.
Remove the 21 screws.
Remove the blower case.
Disengage each claw and remove the upper blower case.
Remove the No. 1 cooler evaporator sub-assembly.
w/ Heater:
Disengage the No. 1 cooler thermistor connector clamp.
Remove the 25 screws.
Remove the blower case.
Remove the upper case.
Remove the No. 1 cooler evaporator sub-assembly.
88304A
8.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY (for LHD)
Disengage the No. 1 cooler thermistor connector clamp.
Remove the 28 screws.
Remove the blower case.
Remove the upper case.
Remove the No. 1 cooler evaporator sub-assembly.
88625
9.REMOVE NO. 1 COOLER THERMISTOR
87107A
10.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY (w/ Heater)
Remove the bolt.
Remove the heater radiator unit sub-assembly.
Use the same procedure for the RHD and LHD vehicle.