Use the same procedure for the LHD and RHD vehicle.
The procedure listed below is for the RHD vehicle.
87138C
1.INSPECT BLOWER RESISTOR
| *a | Component without harness connected
(Blower Resistor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 3.12 to 3.60 Ω |
| 3 - 4 | Always | 1.45 to 1.67 Ω |
| 2 - 4 | Always | 0.52 to 0.60 Ω |
If the result is not as specified, replace the blower resistor.