Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for K3-VE) › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0015231 COMPRESSOR(for K3-VE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for K3-VE)  REASSEMBLY  


PROCEDURE

Hide 88410 1.INSTALL MAGNET CLUTCH ASSEMBLY

I102648

a.

Install the magnet clutch stator with the parts shown in the illustration aligned.


b.
I102849

Using a snap ring expander, install a new snap ring with the chamfered side facing up.


c.
I102850

Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



d.

Install the compressor washer(s) and magnet clutch hub.

NOTICE:

Do not change the combination of the compressor washer(s) used before disassembly.



e.
E231812N01
1.021,0.25 0.844,0.938 false 1.052,0.156 1.802,0.469 0.75,0.313 10 SST

Using SST, hold the magnet clutch hub and install the bolt.

SST
09985-00270  

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)

NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.



Hide 2.INSPECT MAGNET CLUTCH CLEARANCE

E225537C04
0.094,0.125 0.396,0.438 0.302,0.313 10 *a
*a Component without harness connected
(Magnet Clutch Assembly)


a.

Clamp the cooler compressor in a vise.


b.

Set a dial indicator on the magnet clutch hub.


c.

Connect the positive (+) lead of the battery terminal 1 of the magnet clutch connector. Turn the magnet clutch on and off by connecting and disconnecting the negative (-) lead of the battery and from the ground wire and measure the clearance.

Standard clearance:

0.25 to 0.50 mm (0.01 to 0.02 in.)


If the measured value is not within the standard range, remove the magnet clutch hub and adjust the clearance using compressor washers to obtain the standard clearance.

Compressor washer thickness:

0.1 mm (0.004 in.)

0.3 mm (0.012 in.)

0.5 mm (0.020 in.)


NOTICE:

Adjustment should be performed with 3 or fewer magnet clutch washers.



d.

Remove the cooler compressor assembly from the vise.