Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER(for K3-VE) › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0015233 CONDENSER(for K3-VE) A

HEATING / AIR CONDITIONING  CONDENSER(for K3-VE)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LHD and RHD vehicle.

·

The procedure listed below is for the RHD vehicle.



PROCEDURE

Hide 88474 1.INSTALL COOLER DRYER

a.
I105130C04
1.479,1.646 0.896,1.594 false 0.698,1.49 1.135,1.948 0.438,0.458 10 *1
*1 Modulator


Using needle nose pliers, install the cooler dryer into the modulator.


b.
E101932

Apply sufficient compressor oil to the O-ring and the fitting surface of the cap.

Compressor oil:

ND-OIL 8 or equivalent



c.
I105129C08
1.563,1.208 1.115,1.302 false 1.479,1.698 1.031,1.802 false 0.885,1.229 1.292,1.615 0.406,0.385 10 *1 0.823,1.729 1.292,2.125 0.469,0.396 10 *2
*1 14 mm Straight Hexagon Wrench
*2 Modulator


Using a 14 mm straight hexagon wrench, install the cap onto the modulator.

Torque:
2.9 N*m (30 kgf*cm, 26 in.*lbf)