Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR › 2011.11–2014.04
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0015234 FRONT EVAPORATOR TEMPERATURE SENSOR G

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 88625 1.INSPECT NO. 1 COOLER THERMISTOR

a.
E248043
0.521,1.177 0.74,0.75 false 1.094,2.729 1.375,2.458 false 0.094,0.063 0.406,0.26 0.313,0.198 10 *a 0.75,0.635 1.063,0.833 0.313,0.198 10 *b 0.333,1.74 0.646,1.938 0.313,0.198 10 *d 2.875,4.198 3.188,4.396 0.313,0.198 10 *e 1.427,2.344 1.74,2.542 0.313,0.198 10 *c
*a Component without harness connected
(No. 1 Cooler Thermistor)
*b Sensing Portion
*c Acceptable Range
*d Resistance (kΩ)
*e Temperature (°C (°F))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 -10°C (14°F) 7.30 to 9.10 kΩ
-5°C (23°F) 5.65 to 6.95 kΩ
0°C (32°F) 4.40 to 5.35 kΩ
5°C (41°F) 3.40 to 4.15 kΩ
10°C (50°F) 2.70 to 3.25 kΩ
15°C (59°F) 2.14 to 2.58 kΩ
20°C (68°F) 1.71 to 2.05 kΩ
25°C (77°F) 1.38 to 1.64 kΩ
30°C (86°F) 1.11 to 1.32 kΩ


NOTICE:
·

Touching the sensor even slightly may change the resistance value. Hold the sensor connector.

·

When measuring the resistance, the temperature of the sensor and the cooler thermistor must be the same.



HINT:

As the temperature increases, the resistance decreases (See the graph).


If the result is not as specified, replace the No. 1 cooler thermistor.