88635R
1.REMOVE BLOWER RESISTOR
Disconnect the connector and remove the screw and the blower resistor.
88544A
2.REMOVE UPPER COOLER BLOWER CASE
Disconnect the fuse while pushing it as indicated by the arrow shown in the illustration.
Remove the 14 screws and the upper cooler blower case.
88605W
3.REMOVE WIRING AIR CONDITIONING HARNESS SUB-ASSEMBLY
Disconnect the connector and remove the wiring air conditioning harness sub-assembly.
4.REMOVE FUSE SET (w/ FUSE SET)
Disconnect the connector and remove the fuse set from the wiring air conditioning harness sub-assembly.
88706F
5.REMOVE LIQUID TUBE SUB-ASSEMBLY
Loosen the flare nut and remove the liquid tube sub-assembly.
Remove the O-ring from the liquid tube sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88578B
6.REMOVE NO. 1 COOLER PACKING
Remove the No. 1 cooler packing.
88519A
7.REMOVE REMOTE BULB HOLDER PARTS
Remove the remote bulb holder parts.
88515B
8.REMOVE REAR COOLING UNIT EXPANSION VALVE
Loosen the flare nut and remove the rear cooling unit expansion valve.
88501R
9.REMOVE EVAPORATOR SUB-ASSEMBLY
Remove the 2 screws.
Remove the 2 guides and the evaporator sub-assembly.
Remove the O-ring from the evaporator sub-assembly.
88504A
10.REMOVE BLOWER CASE SUB-ASSEMBLY