88504A
1.INSTALL BLOWER CASE SUB-ASSEMBLY
88501R
2.INSTALL EVAPORATOR SUB-ASSEMBLY
Install a new O-ring to the evaporator sub-assembly.
Sufficiently apply compressor oil (ND-OIL 8) to the O-ring and the fitting surface of the evaporator sub-assembly.
ND-OIL 8 or equivalent
Fit the 2 guides and install the evaporator sub-assembly with the 2 screws.
88515B
3.INSTALL REAR COOLING UNIT EXPANSION VALVE
Install the rear cooling unit expansion valve with the union nut.
88519A
4.INSTALL REMOTE BULB HOLDER PARTS
Install the remote bulb holder parts.
88578B
5.INSTALL NO. 1 COOLER PACKING
Install the new No. 1 cooler packing.
88706F
6.INSTALL LIQUID TUBE SUB-ASSEMBLY
Install a new O-ring to the liquid tube sub-assembly.
Sufficiently apply compressor oil (ND-OIL 8) to the O-ring and the fitting surface of the liquid tube sub-assembly.
ND-OIL 8 or equivalent
Install the liquid tube sub-assembly with the flare nut.
7.INSTALL FUSE SET (w/ FUSE SET)
Connect the connector to install the fuse set to the wiring air conditioning harness sub-assembly.
88605W
8.INSTALL WIRING AIR CONDITIONING HARNESS SUB-ASSEMBLY
Connect the connector to install the wiring air conditioning harness sub-assembly.
88544A
9.INSTALL UPPER COOLER BLOWER CASE
Install the upper cooler blower case with the 14 screws.
Install the fuse as shown in the illustration.
Install the clamp and the connector.
88635R
10.INSTALL BLOWER RESISTOR
Install the blower resistor with the screw.
Connect the connector.