84732H
1.INSPECT HEATER BLOWER SWITCH
| *a | Component without harness connected
(Heater Blower Switch) |
Check the heater blower switch resistance.
Using an ohmmeter, measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
|---|---|---|
| ALL - 4 | OFF | 10 kΩ or higher |
| 4 - 3 | 1 | Below 1 Ω |
| 4 - 3 - 2 | 1 - 2 | Below 1 Ω |
| 4 - 3 - 2 | 2 | Below 1 Ω |
| 4 - 3 - 1 | 2 - 3 | Below 1 Ω |
| 4 - 3 - 1 | 3 | Below 1 Ω |
If the result is not as specified, replace the heater blower switch.