Use the same procedure for the LHD and RHD vehicle.
84810
1.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (B) - 2 (M/U+)
5 (D+) - 4 (M/D+) |
UP | Below 1 Ω |
| 1 (U+) - 2 (M/U+)
4 (M/D+) - 5 (D+) |
OFF | Below 1 Ω |
| 2 (M/U) - 1 (U+)
4 (M/D+) - 3 (B) |
DOWN | Below 1 Ω |