Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door)
RM19Y0E _59 Vehicle Exterior _003016 WINDOW / GLASS _0015253 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Use the same procedure for RH side and LH side.


PROCEDURE

Hide 85720D 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 69803 2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

Hide 68103 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67485B 4.INSTALL REAR DOOR DIVISION BAR SEAL

Hide 67408F 5.INSTALL REAR DOOR REAR LOWER WINDOW GUIDE SUB-ASSEMBLY

Hide 68142C 6.INSTALL REAR DOOR GLASS RUN

Hide 67841E 7.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 69205A 9.INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

Hide 67603 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74640D 11.INSTALL REAR DOOR ASSIST GRIP ASSEMBLY

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)