Use the same procedure for the RHD and LHD vehicle.
76871
1.REMOVE REAR SPOILER (w/ Rear Spoiler)
2.REMOVE REAR WIPER ARM AND BLADE
68131
3.REMOVE BACK DOOR GLASS SUB-ASSEMBLY
| *1 | Protective Tape |
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
| *a | Matchmark |
Place matchmarks on the back door glass sub-assembly and vehicle body on the locations indicated in the illustration.
Matchmarks are not necessary if the back door glass sub-assembly is not going to be reused.
Disconnect the 2 connectors. (w/ Rear Window Defogger)
| *1 | Piano Wire |
From the interior, insert piano wires between the vehicle body and back door glass sub-assembly, as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.
Cut through the adhesive by pulling the piano wire around the back door glass sub-assembly.
When separating the back door glass sub-assembly from the vehicle, be careful not to damage the vehicle's paint or interior/exterior ornaments.
Using suction cups, disengage the 2 clips and remove the back door glass sub-assembly.
Be careful not to drop the back door glass sub-assembly.
64818B
4.REMOVE BACK DOOR GLASS SPACER
Using a scraper, remove the back window glass spacer from the back door glass sub-assembly.
Be careful not to damage the back door glass sub-assembly.
Even if using a new back door glass sub-assembly, clean the back door glass sub-assembly with a non-residue solvent.
64828
5.REMOVE BACK WINDOW GLASS CLIP LH
Using a scraper, remove the back door glass clip LH from the back door glass sub-assembly.
Be careful not to damage the back door glass sub-assembly.
Even if using a new back door glass sub-assembly, clean the back door glass sub-assembly with a non-residue solvent.
64827A
6.REMOVE BACK WINDOW GLASS CLIP RH
Using a scraper, remove the back window glass clip RH from the back door glass sub-assembly.
Be careful not to damage the back door glass sub-assembly.
Even if using a new back door glass sub-assembly, clean the back door glass sub-assembly with a non-residue solvent.