Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SWITCH › 2011.11–2015.08
RM19Y0E _59 Vehicle Exterior _003016 WINDOW / GLASS _0015257 WINDOW DEFOGGER SWITCH G

WINDOW / GLASS  WINDOW DEFOGGER SWITCH  INSPECTION  


CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RHD and LHD vehicle.


PROCEDURE

Hide 84790 1.INSPECT REAR WINDOW DEFOGGER SWITCH ASSEMBLY

B270502
1.385,0.333 1.885,0.927 true 1.677,1.885 1.677,2.5 true 1.083,3.156 1.323,2.667 true 1.385,1.885 1.49,2.51 true 0.323,1.667 0.875,2.104 0.552,0.438 10 *a 1.188,0.229 1.802,0.76 0.615,0.531 10 *b 1.635,1.677 2.083,2 0.448,0.323 10 B 1.333,1.667 1.708,1.979 0.375,0.313 10 L 0.938,3.135 1.417,3.427 0.479,0.292 10 E
*a Component without harness connected
(Rear Window Defogger Switch Assembly)
*b Rear Window Defogger Switch Light


a.

Check the rear window defogger switch assembly.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (D) - 4 (L) Defogger switch On Below 1 Ω
3 (D) - 4 (L) Defogger switch Off 1 MΩ or higher




b.

Check that the rear window defogger switch light illuminates.

i.

Apply battery voltage to the rear window defogger switch assembly and check that the light illuminates.

OK:
Measurement Condition Switch Condition Specified Condition
Battery positive (+) → 3 (B)
Battery negative (-) → 5 (E)
Defogger switch On Illuminates
Defogger switch Off Does not Illuminate