| *1 | Centering Bolt |
| *2 | Standard Bolt |
Centering bolts are used to mount the door hinge onto the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute standard bolts (with flange) for the centering bolts when making adjustments.
67005
1.INSPECT BACK DOOR
Check that the clearance measurements are within the standard ranges.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| *a | 6.0 to 9.0 mm
(0.236 to 0.354 in.) |
*b | -0.5 to 2.5 mm
(-0.020 to 0.098 in.) |
| *c | 4.0 to 7.0 mm
(0.158 to 0.276 in.) |
*d | 5.0 to 8.0 mm
(0.197 to 0.315 in.) |
| *e | 24.3 to 27.3 mm
(0.957 to 1.075 in.) |
*f | 4.3 to 7.3 mm
(0.169 to 0.287 in.) |
| *g | -1.3 to 1.7 mm
(-0.051 to 0.067 in.) |
- | - |
67005
2.ADJUST BACK DOOR
Adjust the door position.
Vertically adjust the door by loosening the door side hinge bolts.
Horizontally adjust the door by loosening the door side hinge nuts.
Adjust the striker position.
Adjust the striker position by slightly loosening the striker mounting bolts and hitting the striker with a plastic hammer.
Tighten the striker mounting bolts after the adjustment.