Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM19Y0E _59 Vehicle Exterior _003017 DOOR / HATCH _0015265 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 68961 1.INSTALL BACK DOOR STAY BOLT

a.

Clean the threaded portion on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the back door stay bolt.

Adhesive:

Toyota Genuine Adhesive 1324,Three Bond 1324 or equivalent



c.

Install the back door stay bolt.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


Hide 68960 2.INSTALL BACK DOOR STAY ASSEMBLY

B290332
0.854,0.948 1.115,1.698 true 1.083,1.74 1.479,2.073 0.396,0.333 10 *1
*1 Stop Ring


a.

Clean the threaded portion on the back door with a non-residue solvent.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324,Three Bond 1324 or equivalent



c.

Install the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:
·

Avoid touching the stroke portions of the rod as much as possible to prevent foreign matter from attaching to the stroke portions. Be sure to hold the cylinders while servicing.

·

Do not wear cotton gloves or other similar materials when handling the rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any load to the cylinders in the horizontal direction, in order to prevent the rod from being deformed.



Fit the stop ring to the back door stay assembly.


d.

Install the back door stay assembly.

NOTICE:

Install the back door stay while supporting the back door by hand.



e.

Check that the back door stay assembly is attached at the ball joint and that the back door stay assembly cannot be pulled off.