Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
87945
1.REMOVE OUTER MIRROR COVER
| *1 | Protective Tape |
| *2 | Moulding Remover |
Push the upper part of the outer mirror surface and tilt it.
Apply protective tape to the bottom of the outer mirror cover.
Using a moulding remover, disengage the 2 claws.
Disengage the 2 guides and remove the outer mirror.
Disengage the 7 claws from the inside of the mirror body to remove the outer mirror cover.
Remove the 2 screws.
Disengage the claw and remove the outer mirror cover.