Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR
RM19Y0E _59 Vehicle Exterior _003019 WIPER / WASHER _0015273 REAR WIPER MOTOR G

WIPER / WASHER  REAR WIPER MOTOR  INSPECTION  


PROCEDURE

Hide 85110R 1.INSPECT REAR WIPER MOTOR ASSEMBLY

a.
E231722
0.802,0.448 1.49,0.563 true 1.958,0.563 2.604,0.448 true 0.094,0.01 0.5,0.375 0.406,0.365 10 *a 0.667,0.354 1.073,0.708 0.406,0.354 10 + 2.708,0.354 3.135,0.75 0.427,0.396 10 -
*a Component without harness connected
(Rear Wiper Motor Assembly)


Check the operation.

i.

Check to ensure that the rear wiper motor assembly operates when the battery voltage is applied between the terminals.

Specified Condition:
Tester Connection Specified Condition
Battery negative (-) → 2 (-)
Battery positive (+) → 1 (+)
Rear wiper motor operates.


NOTICE:

Check that the body ground is connected.


If the result is not as specified, replace the rear wiper motor assembly.



b.
E236678
0.438,1.385 1.115,0.552 true 2.25,0.25 1.688,0.427 true 2.26,0.167 2.594,0.51 0.333,0.344 10 *a 1.323,0.385 1.719,0.729 0.396,0.344 10 *b 0.333,1.365 0.771,1.708 0.438,0.344 10 *c
*a Operation Angle
*b 107° to 113°
*c Automatic Stop Position


Check the automatic stop position.

i.

Operate the rear wiper motor, then stop the operation.


ii.

Check the automatic stop position when the rear wiper motor operation has stopped.

Standard:

Rear wiper arm stops in the position shown in the illustration.