Use the same procedure for the LHD and RHD vehicle.
The procedure listed below is for the RHD vehicle.
45287
1.REMOVE LOWER STEERING COLUMN COVER
Remove the screw from the lower portion of the lower steering column cover.
While turning the steering wheel assembly to the right and left, remove the 2 screws.
Push the right and left sides of the lower steering column cover to disengage the 4 claws and remove the lower steering column cover.
45286B
2.REMOVE UPPER STEERING COLUMN COVER
Disengage the claw and remove the upper steering column cover.
84650
3.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
| *1 | Protective Tape |
Disconnect the connector.
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.
Do not press the claw too hard, as it may be damaged.