Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Front Side)
RM19Y0E _59 Vehicle Exterior _003019 WIPER / WASHER _0015277 WASHER MOTOR(for Front Side) G

WIPER / WASHER  WASHER MOTOR(for Front Side)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85310 1.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E234786
0.188,0.125 0.667,0.51 0.479,0.385 10 *a 1.875,0.979 2.24,1.323 0.365,0.344 10 1 1.5,1.01 1.896,1.385 0.396,0.375 10 2
*a Component without harness connected
(Windshield Washer Motor and Pump Assembly)


Check the operation of the windshield washer motor and pump assembly.

i.

Fill the windshield washer jar sub-assembly with washer fluid.

HINT:

The operation should be performed with the windshield washer motor and pump assembly installed on the windshield washer jar sub-assembly.



ii.

Connect the positive (+) battery lead to terminal 1, and the negative (-) battery lead to terminal 2.


iii.

Check that washer fluid flows from the windshield washer jar sub-assembly.

Standard:

Washer fluid flows from the windshield washer jar sub-assembly.


If the result is not as specified, replace the windshield washer motor and pump assembly.