Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE(for Front) › 2011.11–2015.08
RM19Y0E _59 Vehicle Exterior _003019 WIPER / WASHER _0015279 WASHER NOZZLE(for Front) G

WIPER / WASHER  WASHER NOZZLE(for Front)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85035 1.INSPECT WASHER NOZZLE SUB-ASSEMBLY

a.

With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

E231705
1.083,0.875 1.833,1.198 true 0.906,2.854 2.26,2.656 true 2.865,2.99 3.219,2.99 true 4.094,3 4.448,3 true 3.25,0.083 3.615,0.448 0.365,0.365 10 *a 3.927,3.594 4.156,3.802 0.229,0.208 10 *h 3.146,3.583 3.438,3.802 0.292,0.219 10 *g 0.927,0.76 1.333,1.115 0.406,0.354 10 *i 0.781,2.792 1.208,3.135 0.427,0.344 10 *j 3.302,2.906 3.688,3.26 0.385,0.354 10 *e 4.49,1.885 4.958,2.313 0.469,0.427 10 *d 2.427,1.917 2.802,2.281 0.375,0.365 10 *c 3.885,0.323 4.354,0.781 0.469,0.458 10 *b 3.948,2.938 4.292,3.354 0.344,0.417 10 *f
*a 23.8 mm (0.937 in.) *b 76.6 mm (3.015 in.)
*c 537.9 mm (21.17 in.) *d 556.8 mm (21.92 in.)
*e 86.7 mm (3.413 in.) *f 89.6 mm (3.527 in.)
*g 187.0 mm (7.362 in.) *h 207.4 mm (8.165 in.)
*i Upper Limit *j Lower Limit


OK:

Washer fluid hits the windshield in the area shown in the illustration.


If the result is not as specified, replace the washer nozzle.