PRECAUTION FOR HEADLIGHT BULB REPLACEMENT
If even a thin film of oil is left on the surface of an halogen bulb, its service life will be shortened because the light will burn at a higher temperature. When replacing a bulb, be sure to hold the flanged part of the light so that your hand will not contact the glass part of the bulb.
As the internal pressure of halogen bulb is high, dropping, hitting or damaging a bulb may result in it exploding and shattering.
Always prepare a new bulb for immediate replacement. While replacing a bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.
Always replace a bulb with another bulb of the same wattage.
If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.
Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may fill with water through gaps around the socket if it is not installed securely.
PRECAUTION FOR HEADLIGHT AIMING ADJUSTMENT
When the headlights are illuminated, do not cover the headlights for 3 minutes or more.
As the outer lens of the headlight is made of resin, the resulting heat created when covering the headlight for an extended period of time may deform the headlight.