Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY(for Single Beam Headlight) › 2011.11–2015.08
RM19Y0E _59 Vehicle Exterior _003020 LIGHTING (EXT) _0015282 HEADLIGHT ASSEMBLY G

LIGHTING (EXT)  HEADLIGHT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 81515B 1.INSPECT FRONT TURN SIGNAL LIGHT SOCKET

a.
E184506
1.396,1.406 0.979,1.698 true 2.031,1.396 2.552,1.698 true 0.198,0.052 0.75,0.479 0.552,0.427 10 *a 2.635,1.635 3.031,2.021 0.396,0.385 10 - 0.833,1.677 1.271,2.052 0.438,0.375 10 +
*a Component without harness connected
(Front Turn Signal Light Socket)


Apply battery voltage to the terminals and check that the front turn signal light comes on.

Standard:
Tester Connection Condition
Battery positive (+) → 2 (+)
Battery negative (-) → 1 (-)
Front turn signal light comes on


HINT:

Use a new bulb or know good one.



Hide 81615D 2.INSPECT CLEARANCE LIGHT SOCKET

a.
E175211
1.448,1.292 1.135,1.521 true 1.948,1.292 2.365,1.542 true 1.833,1.094 2.188,1.479 0.354,0.385 10 1 1.49,1.094 1.896,1.479 0.406,0.385 10 2 0.125,0.083 0.583,0.49 0.458,0.406 10 *a 0.969,1.438 1.375,1.76 0.406,0.323 10 - 2.417,1.469 2.792,1.792 0.375,0.323 10 +
*a Component without harness connected
(Clearance Light Socket)


Apply battery voltage to the terminals and check that the clearance light comes on.

Standard:
Tester Connection Condition
Battery positive (+) → 1 (+)
Battery negative (-) → 2 (-)
Clearance light comes on


HINT:

Use a new bulb or know good one.