Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY
RM19Y0E _59 Vehicle Exterior _003020 LIGHTING (EXT) _0015284 REAR COMBINATION LIGHT ASSEMBLY G

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 81560 1.INSPECT REAR COMBINATION LIGHT ASSEMBLY

a.
E239056
0.26,0.146 0.688,0.479 0.427,0.333 10 *a
*a Component without harness connected
(Rear Combination Light Assembly)


Apply battery voltage to the rear combination light assembly connector and check the light comes on.

Standard:
Tester Connection Condition
Battery positive (+) → 2
Battery negative (-) → 5
Stop light comes on
Battery positive (+) → 1
Battery negative (-) → 5
Tail light comes on
Battery positive (+) → 3
Battery negative (-) → 5
Turn signal light comes on
Battery positive (+) → 4
Battery negative (-) → 5
Back up light comes on


HINT:

Use a new bulb or know good one.