Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81550H
1.REMOVE TAIL AND STOP LIGHT BULB
Turn the rear combination light socket and wire sub-assembly LH with the tail and stop light bulb in the direction indicated by the arrow in the illustration and remove them as a unit.
Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly LH.
81550L
2.REMOVE REAR TURN SIGNAL LIGHT BULB
Turn the rear combination light socket and wire sub-assembly LH with the rear turn signal light bulb in the direction indicated by the arrow in the illustration and remove them as a unit.
Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly LH.
81550N
3.REMOVE BACK UP LIGHT BULB
Turn the rear combination light socket and wire sub-assembly LH with the back up light bulb in the direction indicated by the arrow in the illustration and remove them as a unit.
Remove the back up light bulb from the rear combination light socket and wire sub-assembly LH.