Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › 2011.11–2015.08
RM19Y0E _59 Vehicle Exterior _003020 LIGHTING (EXT) _0015288 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LHD and RHD vehicle.

·

The procedure listed below is for the RHD vehicle.



PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E145545
0.156,0.115 0.573,0.521 0.417,0.406 10 *a
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 - 4 Hazard warning signal switch off 10 kΩ or higher
Hazard warning signal switch on Below 1 Ω



b.

Apply battery voltage to the connector and check the LED illumination condition.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
LED illuminates


If the result is not as specified, there may be a malfunction in the hazard warning signal switch assembly.