Use the same procedure for the LHD and RHD vehicle.
The procedure listed below is for the RHD vehicle.
84340
1.INSPECT STOP LIGHT SWITCH ASSEMBLY
| *a | Component without harness connected
(Stop Light Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pin not pushed | Below 1 Ω |
| Pin pushed | 10 kΩ or higher |
If the result is not as specified, replace the stop light switch assembly.