Home › Vehicle Exterior › HORN › RELAY › 2011.11–2015.08
RM19Y0E _59 Vehicle Exterior _003021 HORN _0015295 RELAY G

HORN  RELAY  INSPECTION  


PROCEDURE

Hide 86530 1.INSPECT HORN RELAY ASSEMBLY

a.
A184106N06
2.531,1.125 2.927,1.125 true 2.531,1.625 2.938,1.625 true 1.573,0.188 1.698,0.188 1.698,0.188 2.031,0.563 true 3.031,0.177 2.906,0.177 2.906,0.177 2.625,0.563 true 0.198,0.771 0.615,1.177 0.417,0.406 10 3 1.208,0.76 1.604,1.135 0.396,0.375 10 5 0.198,1.333 0.615,1.729 0.417,0.396 10 2 1.208,1.333 1.594,1.677 0.385,0.344 10 1 2.99,1.531 3.375,1.927 0.385,0.396 10 3 2.958,1.042 3.333,1.417 0.375,0.375 10 5 3.083,0.094 3.417,0.458 0.333,0.365 10 2 1.438,0.115 1.865,0.5 0.427,0.385 10 1

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage is applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the horn relay assembly.