Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › SIDE MUDGUARD
RM19Y0E _59 Vehicle Exterior _003022 EXTERIOR PANELS / TRIM _0015300 SIDE MUDGUARD A

EXTERIOR PANELS / TRIM  SIDE MUDGUARD  INSTALLATION  


PROCEDURE

Hide 76921D 1.INSTALL NO. 1 SIDE MUDGUARD PROTECTOR

HINT:

When installing the No. 1 side mudguard protector, heat the rocker panel moulding LH and the No. 1 side mudguard protector using a heat light.


Heating Temperature
Item Temperature
Rocker panel moulding LH 40 to 60°C (104 to 140°F)
No. 1 side mudguard protector 20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the No. 1 side mudguard protector or the rocker panel moulding LH excessively.


a.

Clean the rocker panel moulding LH surface.

i.

Using a heat light, heat the rocker panel moulding LH surface.


ii.

Remove the double-sided tape from the rocker panel moulding LH.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install the new No. 1 side mudguard protector.

i.

Using a heat light, heat the No. 1 side mudguard protector and the rocker panel moulding LH.


ii.

Apply primer to the rocker panel moulding LH where the No. 1 side mudguard protector will be installed.

NOTICE:

Do not let the primer dry.



iii.

Remove the peeling paper from the face of the No. 1 side mudguard protector.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



iv.

Install the new No. 1 side mudguard protector.



Hide 75852 2.INSTALL ROCKER PANEL MOULDING LH

a.

Engage the 10 clips to install the rocker panel moulding LH.


b.

Install the screw.


Hide 76924G 3.INSTALL ROCKER PANEL MOULDING RETAINER

a.

Install the 9 side mudguard retainers.