Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING
RM19Y0E _59 Vehicle Exterior _003022 EXTERIOR PANELS / TRIM _0015302 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 68230C 1.INSTALL REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

a.
B289369

Engage the 6 claws and 2 clips and install a new rear door glass outer weatherstrip assembly.


b.

Remove the protective tape.


Hide 68103 2.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67485B 3.INSTALL REAR DOOR DIVISION BAR SEAL

Hide 67408F 4.INSTALL REAR DOOR REAR LOWER WINDOW GUIDE SUB-ASSEMBLY

Hide 68142C 5.INSTALL REAR DOOR GLASS RUN

Hide 67842E 6.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 86160B 7.INSTALL REAR SPEAKER ASSEMBLY

Hide 69206C 8.INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

Hide 67603 9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74640D 10.INSTALL REAR DOOR ASSIST GRIP ASSEMBLY