Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING
RM19Y0E _59 Vehicle Exterior _003022 EXTERIOR PANELS / TRIM _0015302 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 74640D 1.REMOVE REAR DOOR ASSIST GRIP ASSEMBLY

Hide 67603 2.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 69206C 3.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

Hide 86160B 4.REMOVE REAR SPEAKER ASSEMBLY

Hide 67842E 5.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 68142C 6.REMOVE REAR DOOR GLASS RUN

Hide 67408F 7.REMOVE REAR DOOR REAR LOWER WINDOW GUIDE SUB-ASSEMBLY

Hide 67485B 8.REMOVE REAR DOOR DIVISION BAR SEAL

Hide 68103 9.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 68230C 10.REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

a.
B289367
0.76,0.969 1.51,1.719 true 0.604,0.885 1.042,1.219 0.438,0.333 10 *1
*1 Protective Tape


Apply protective tape to the door panel in the rear door glass outer weatherstrip assembly.


b.
B289368
2.854,1.563 1.854,1.719 true 2.875,1.469 3.24,1.854 0.365,0.385 10 *1
*1 Moulding remover


Using a moulding remover, disengage the 6 claws and 2 clips and remove the rear door glass outer weatherstrip assembly.