Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING › 2011.11–2015.08
RM19Y0E _59 Vehicle Exterior _003022 EXTERIOR PANELS / TRIM _0015303 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP

NOTICE:
·

If reusing the clips, do not remove the double sided tape remaining on the clips and where the clips will be installed on the body.

·

If installing new clips, remove the double-sided tape remaining where the clips will be installed on the body and clean the body with a non-residue solvent.

·

Follow these procedures only when replacing the clips.



a.
B125568
2.542,0.729 2.844,0.885 true 1.604,1.177 1.021,0.813 true 2.885,0.833 3.219,1.177 0.333,0.344 10 *1 0.865,0.688 1.229,0.979 0.365,0.292 10 *a
*1 Adhesive
*a 2 to 3 mm Bead of Adhesive


Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to new roof drip side finish moulding clips.

HINT:

Adhesive strength (tensile strength): 13.7 Mpa (140 kgf/cm2, 1987 psi) or more when the temperature is 23°C (73°F).



b.
B270500
0.604,0.792 1.01,1.167 0.406,0.375 10 a 2.24,0.26 2.646,0.625 0.406,0.365 10 b 1.167,4.083 1.552,4.427 0.385,0.344 10 c 2.094,3.458 2.469,3.792 0.375,0.333 10 d

Install new 2 clips in the positions as shown in the illustration. Press in the clips by hand.

Specification:
Area Measurement
a 1.0 to 2.0 mm (0.039 to 0.078 in.)
b 1.2 to 2.2 mm (0.047 to 0.086 in.)
c 1.0 to 2.0 mm (0.039 to 0.078 in.)
d 0.4 to 1.4 mm (0.016 to 0.055 in.)


NOTICE:

After pressing in the clips, wait 30 minutes or more before installing the roof drip side finish moulding.


HINT:
·

Minimum hardening time: 30 minutes.

·

Time needed for complete hardening: 24 hours.




Hide 75552 2.INSTALL ROOF DRIP SIDE FINISH MOULDING LH

a.
B270501

Engage the 2 clips and install the roof drip side finish moulding LH.


b.

Remove the protective tape.