Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING
RM19Y0E _59 Vehicle Exterior _003022 EXTERIOR PANELS / TRIM _0015303 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 75552 1.REMOVE ROOF DRIP SIDE FINISH MOULDING LH

a.
B270498
1.573,1.042 1.417,0.406 1.417,0.406 1.729,1.063 true 1.323,0.219 1.708,0.552 0.385,0.333 10 *1
*1 Protective Tape


Apply protective tape to the roof panel in the area around the roof drip side finish moulding LH.


b.
B270499
0.292,0.979 0.677,1.635 true 0.198,0.802 0.604,1.125 0.406,0.323 10 *1
*1 Moulding Remover


Disengage the 2 clips and remove the roof drip side finish moulding LH.

HINT:
·

Do not remove the roof drip side finish moulding clips unless otherwise specified.

·

When removing the roof drip side finish moulding, be careful not to damage the roof drip side finish moulding clips. If the roof drip side finish moulding clips are damaged, replace them with new ones.