Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)
RM19Y0E _56 Audio / Visual / Telematics _003000 AUDIO / VIDEO _0015166 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the audio and visual system.


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the power switch off.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result:
Proceed to
NEXT




NEXT

3.PROBLEM SYMPTOMS TABLE
3.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table. A
Fault is listed in Problem Symptoms Table. B




A

4.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

B

5.ADJUST, REPAIR OR REPLACE
4.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

NEXT

5.ADJUST, REPAIR OR REPLACE
5.ADJUST, REPAIR OR REPLACE
a.

Adjust, repair or replace as necessary.

Result:
Proceed to
NEXT




NEXT

6.CONFIRMATION TEST
6.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END