The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1.REMOVE FRONT SEAT ASSEMBLY
73230
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/o Seat Belt Warning System)
| *1 | Rubber Band |
Disconnect the 2 rubber bands from the front seat frame with adjuster assembly, and then turn the separate type front seat back cover over.
| *1 | Hook and Loop Fastener |
Unfasten the hook and loop fastener and open the separate type front seat cushion cover.
Remove the bolt, washer and front seat inner belt assembly.
73230
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/ Seat Belt Warning System)
| *1 | Rubber Band |
Disconnect the 2 rubber bands from the front seat frame with adjuster assembly, and then turn the separate type front seat back cover over.
| *1 | Band |
Cut the band.
Disengage the 2 clamps.
| *1 | Hook and Loop Fastener |
Unfasten the hook and loop fastener and open the separate type front seat cushion cover.
Disengage the clamp.
Remove the bolt, washer and front seat inner belt assembly.