The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
73230
1.INSTALL FRONT SEAT INNER BELT ASSEMBLY (w/o Seat Belt Warning System)
| *1 | Protruding Part |
| *2 | Hook and Loop Fastener |
Install the front seat inner belt assembly with the bolt and washer.
Do not place the front seat inner belt assembly over the protruding part of the front seat inner track assembly.
Fasten the hook and loop fastener and close the separate type front seat cushion cover.
Connect the 2 rubber bands on the front seat frame with adjuster assembly.
73230
2.INSTALL FRONT SEAT INNER BELT ASSEMBLY (w/ Seat Belt Warning System)
| *1 | Protruding Part |
| *2 | Hook and Loop Fastener |
Install the front seat inner belt assembly with the bolt and washer.
Do not place the front seat inner belt assembly over the protruding part of the front seat inner track assembly.
Engage the clamp.
Fasten the hook and loop fastener and close the separate type front seat cushion cover.
Engage the 2 clamps.
Secure the wire harness with a new band.
Connect the 2 rubber bands on the front seat frame with adjuster assembly.
3.INSTALL FRONT SEAT ASSEMBLY