Home › Engine / Hybrid System › 3SZ-VE COOLING › COOLING FAN SYSTEM › 2014.04–2015.08
RM19Y0E _51 Engine / Hybrid System _002978 3SZ-VE COOLING _0015052 COOLING FAN SYSTEM G

3SZ-VE COOLING  COOLING FAN SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK COOLING FAN OPERATION AT LOW TEMPERATURE (BELOW 83°C (181°F))

a.

Check that the cooling fan does not rotate when the ignition switch is turned to ON with the A/C switch off.


b.

Disconnect the engine coolant temperature sensor connector, then turn the ignition switch to ON. Check that the cooling fan rotates.


Hide 2.CHECK COOLING FAN OPERATION AT HIGH TEMPERATURE (ABOVE 98°C (208°F) (w/o COOLING FAN RESISTER))

a.

Warm up the engine and check that the A/C switch is off.


b.

Check that the cooling fan starts rotating when the coolant temperature is 98°C (208°F) or higher.


c.

Check that the cooling fan stops rotating when the coolant temperature is 95°C (203°F) or lower.


Hide 3.CHECK COOLING FAN OPERATION (LOW SPEED) AT HIGH TEMPERATURE (ABOVE 98°C (208°F) (w/ COOLING FAN RESISTER))

a.

Warm up the engine and check that the A/C switch is off.


b.

Check that the cooling fan starts rotating when the coolant temperature is 98°C (208°F) or higher.


c.

Check that the cooling fan stops rotating when the coolant temperature is 95°C (203°F) or lower.


Hide 4. COOLING FAN OPERATION (HIGH SPEED) AT HIGH TEMPERATURE (ABOVE 100°C (212°F) (w/ COOLING FAN RESISTER))

a.

Warm up the engine and check that the A/C switch is off.


b.

Check that the cooling fan speed changes to high speed mode when the coolant temperature is higher than 100°C (212°F) and the engine speed is 1700 rpm or higher.


c.

Check that the cooling fan speed changes to low speed mode when the coolant temperature is 97 °C (207 °F) or lower, or the engine speed is 1500 rpm or lower.


Hide 5.INSPECT COOLING FAN MOTOR

A269814C02
1.917,0.333 2.313,0.677 0.396,0.344 10 *a 0.281,1.5 0.948,1.927 0.667,0.427 10 *b
*a Ammeter
*b Battery


a.

Disconnect the cooling fan motor connector.


b.

Check that the cooling fan rotates smoothly when the battery is connected to the fan motor connector.


c.

Using an ammeter, measure the current with step (b) maintained.

Standard current:

6.4 to 9.4 A at 20°C (68°F) for 80W cooling fan motor

10.0 to 15.0 A at 20°C (68°F) for 160W cooling fan motor



d.

Connect the cooling fan motor connector.