The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1.REMOVE EXTINGUISHER (w/ Extinguisher)
Remove the extinguisher.
2.REMOVE EXTINGUISHER BRACKET (w/ Extinguisher)
Remove the 2 screws and extinguisher bracket.
71910A
3.REMOVE FRONT SEAT HEADREST ASSEMBLY
| *1 | Lock Button |
Push in the lock button of the front seat headrest support assembly and remove the front seat headrest assembly.
72157A
4.REMOVE SEAT INNER TRACK BRACKET COVER
Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.
Disengage the claw to remove the seat inner track bracket cover.
71139D
5.REMOVE FRONT SEAT NO. 1 LEG COVER
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws to remove the front seat No. 1 leg cover.
6.REMOVE FRONT SEAT ASSEMBLY (w/ Seat Belt Warning System)
Disengage the floor wire harness clamp from the seat belt hanger bracket.
Disconnect the front seat inner belt assembly connector.
| *a | Front Side |
| *b | Rear Side |
Remove the 2 bolts on the rear side of the front seat assembly.
Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.
Remove the 2 bolts on the front side of the front seat assembly.
Remove the front seat assembly from the cabin.
Be careful not to damage the vehicle body.
7.REMOVE FRONT SEAT ASSEMBLY (w/o Seat Belt Warning System)
| *a | Front Side |
| *b | Rear Side |
Remove the 2 bolts on the rear side of the front seat assembly.
Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.
Remove the 2 bolts on the front side of the front seat assembly.
Remove the front seat assembly from the cabin.
Be careful not to damage the vehicle body.