The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1.INSTALL FRONT SEAT ASSEMBLY (w/ Seat Belt Warning System)
Place the front seat assembly in the cabin.
Be careful not to damage the vehicle body.
Temporarily install the front seat assembly with the 4 bolts.
Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.
| *a | Front Side |
| *b | Rear Side |
Tighten the 2 bolts on the front side of the front seat assembly.
Tighten the bolts in the order indicated in the illustration.
Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.
Tighten the 2 bolts on the rear side of the front seat assembly.
Tighten the bolts in the order indicated in the illustration.
Connect the front seat inner belt assembly connector.
Engage the floor wire harness clamp to the seat belt hanger bracket.
2.INSTALL FRONT SEAT ASSEMBLY (w/o Seat Belt Warning System)
Place the front seat assembly in the cabin.
Be careful not to damage the vehicle body.
Temporarily install the front seat assembly with the 4 bolts.
Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.
| *a | Front Side |
| *b | Rear Side |
Tighten the 2 bolts on the front side of the front seat assembly.
Tighten the bolts in the order indicated in the illustration.
Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.
Tighten the 2 bolts on the rear side of the front seat assembly.
Tighten the bolts in the order indicated in the illustration.
71139D
3.INSTALL FRONT SEAT NO. 1 LEG COVER
Engage the 3 claws to install the front seat No. 1 leg cover.
72157A
4.INSTALL SEAT INNER TRACK BRACKET COVER
Engage the claw to install the seat inner track bracket cover.
71910A
5.INSTALL FRONT SEAT HEADREST ASSEMBLY
Push in the lock button of the front seat headrest support assembly and install the front seat headrest assembly.
6.INSTALL EXTINGUISHER BRACKET (w/ Extinguisher)
Install the extinguisher bracket with the 2 screws.
7.INSTALL EXTINGUISHER (w/ Extinguisher)
Install the extinguisher.