Wear protective gloves. Sharp surfaces on the rear seat back frame sub-assembly and rear seat cushion spring assembly could cause injuries to your hands.
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
72637A
1.REMOVE REAR SEAT LOCK HANDLE
| *1 | Protective Tape |
| *2 | Snap Ring |
Using a screwdriver with its tip wrapped in protective tape, pull out the snap ring and remove the rear seat lock handle.
71833D
2.REMOVE REAR SEAT RECLINING COVER
Remove the screw.
Disengage the 2 claws to remove the rear seat reclining cover.
79011
3.REMOVE NO. 1 SEAT CUSHION COVER SUB-ASSEMBLY
Remove the 2 screws.
Disengage the 4 claws to remove the No. 1 seat cushion cover sub-assembly.
71878A
4.REMOVE REAR SEAT INNER RECLINING COVER
Disengage the claw to remove the rear seat inner reclining cover.
5.REMOVE REAR NO. 1 SEAT BACK ASSEMBLY
| *1 | E-Ring |
| *2 | Bushing |
Remove the 2 bolts, E-ring and rear No. 1 seat back assembly.
Remove the bushing.
71940A
6.REMOVE REAR SEAT HEADREST ASSEMBLY
| *1 | Lock Button |
Push in the lock button of the rear seat headrest support assembly and remove the rear seat headrest assembly.
71956B
7.REMOVE REAR SEAT HEADREST SUPPORT ASSEMBLY
| *1 | Hook |
Detach the hook and open the fastener.
Disengage the 2 claws to remove the rear seat headrest support assembly.
71956B
8.REMOVE REAR SEAT HEADREST SUPPORT
Disengage the 2 claws to remove the rear seat headrest support.
71077S
9.REMOVE SEPARATE TYPE REAR SEAT BACK COVER
Remove the 13 hog rings and separate type rear seat back cover from the separate type rear seat back pad.
71651S
10.REMOVE SEPARATE TYPE REAR SEAT BACK PAD
Remove the separate type rear seat back pad from the rear seat back frame sub-assembly.
71671A
11.REMOVE REAR SEAT BACK SILENCER PAD A
Remove the rear seat back silencer pad A from the separate type rear seat back pad.
72159A
12.REMOVE REAR SEAT TRACK BRACKET COVER (for Slide Seat Type)
Disengage the 2 claws to remove the rear seat track bracket cover.
Use the same procedure for the other rear seat track bracket covers.
79959
13.REMOVE REAR SEAT LEG COVER (for Slide Seat Type)
Remove the screw, rear seat cushion and rear seat leg cover.
71324A
14.REMOVE REAR SEAT CUSHION (for Non-slide Seat Type)
Remove the screw and rear seat cushion.
72665C
15.REMOVE REAR SEAT LOCK COVER (for Slide Seat Type)
Remove the 2 screws and rear seat lock cover.
72694
16.REMOVE REAR SEAT LOCK COVER (for Non-slide Seat Type)
Remove the 2 screws and rear seat lock cover.
72995
17.REMOVE REAR SEAT CUSHION COVER (w/ Rear Seat Cushion Cover)
Remove the 4 screws and rear seat cushion cover.
73330C
18.REMOVE REAR SEAT LAP TYPE BELT ASSEMBLY
72670B
19.REMOVE REAR SEAT CUSHION LOCK ASSEMBLY (for Slide Seat Type)
| *1 | Rear Seat Lock Control Cable |
Disengage the clamp and disconnect the rear seat lock control cable.
Remove the 2 bolts and rear seat cushion lock assembly.
72670B
20.REMOVE REAR SEAT CUSHION LOCK ASSEMBLY (for Non-slide Seat Type)
| *1 | Rear Seat Lock Control Cable |
Disengage the clamp and disconnect the rear seat lock control cable.
Remove the 2 bolts and rear seat cushion lock assembly.
72670B
21.REMOVE REAR SEAT CUSHION LOCK ASSEMBLY (w/ Rear Seat Cushion Cover)
| *1 | Rear Seat Lock Control Cable |
Disengage the clamp and disconnect the rear seat lock control cable.
Remove the 2 bolts and rear seat cushion lock assembly.
72670B
22.REMOVE REAR SEAT OUTER CUSHION LOCK ASSEMBLY (w/ Rear Seat Cushion Cover)
| *1 | Rear Seat Lock Control Cable |
Disengage the clamp and disconnect the rear seat lock control cable.
Remove the 2 bolts and rear seat outer cushion lock assembly.
71308E
23.REMOVE REAR SEAT LEG SUB-ASSEMBLY (for Slide Seat Type)
Remove the 3 nuts and rear seat leg sub-assembly.
71308E
24.REMOVE REAR SEAT LEG SUB-ASSEMBLY (w/ Rear Seat Cushion Cover)
Remove the 6 nuts and rear seat leg sub-assembly.
72160C
25.REMOVE REAR NO. 1 SEAT OUTER TRACK ASSEMBLY (for Slide Seat Type)
Remove the 2 bolts and rear No. 1 seat outer track assembly.
72170C
26.REMOVE REAR NO. 1 SEAT INNER TRACK ASSEMBLY (for Slide Seat Type)
Use the same procedure as for the rear No. 1 seat outer track assembly.
72160C
27.REMOVE REAR NO. 1 SEAT OUTER TRACK ASSEMBLY (w/ Rear Seat Cushion Cover)
Remove the 2 bolts and rear No. 1 seat outer track assembly.
Slide the coil spring in the direction of the arrow, and then release the hook of the seat track equalizing wire sub-assembly from the rear No. 1 seat outer track assembly.
72170C
28.REMOVE REAR NO. 1 SEAT INNER TRACK ASSEMBLY (w/ Rear Seat Cushion Cover)
Use the same procedure as for the rear No. 1 seat outer track assembly.
29.REMOVE REAR NO. 1 SEAT CUSHION OUTER LEG (for Non-slide Seat Type)
| *1 | E-Ring |
| *2 | Pin |
| *3 | Rear No. 1 Seat Turn Spring |
Remove the E-ring and pin.
Remove the rear No. 1 seat turn spring and rear No. 1 seat cushion outer leg.
30.REMOVE REAR NO. 1 SEAT CUSHION INNER LEG (for Non-slide Seat Type)
Use the same procedure as for the rear No. 1 seat cushion outer leg.
72695A
31.REMOVE REAR SEAT LOCK CONTROL CABLE (for Slide Seat Type)
| *1 | Band |
Cut the 2 bands.
Disengage the clamp to remove the rear seat lock control cable.
72695A
32.REMOVE REAR SEAT LOCK CONTROL CABLE (for Non-slide Seat Type)
| *1 | Band |
Cut the band.
Disengage the 2 clamps to remove the rear seat lock control cable.
72695A
33.REMOVE REAR SEAT LOCK CONTROL CABLE (w/ Rear Seat Cushion Cover)
| *1 | Band |
Cut the 3 bands.
Disengage the clamp to remove the rear seat lock control cable.
71075D
34.REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER
Open the fastener.
Remove the 9 hog rings.
Remove the 14 hog rings and separate type rear seat cushion cover from the rear seat cushion pad.
71611A
35.REMOVE REAR SEAT CUSHION PAD
Remove the rear seat cushion pad from the rear seat cushion spring assembly.
71621A
36.REMOVE REAR SEAT CUSHION SILENCER PAD
Remove the rear seat cushion silencer pad from the rear seat cushion pad.