Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR › from 2015.08
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0015138 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  REMOVAL  


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surface.


Hide 2.REMOVE BRAKE ACTUATOR WITH BRACKET

a.
C332228

Turn down the lock lever to disconnect the brake actuator connector from the brake actuator assembly.

NOTICE:

Be careful not to allow brake fluid to enter the removed connector.



b.
C332229

Using a 10 mm union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.


c.
C333884C01
1.917,1.375 2.083,1.375 true 1.156,0.854 1.323,0.854 true 2.417,1.021 2.417,1.188 2.417,1.188 2.75,1.188 true 2.167,0.865 2.167,1.031 true 1.917,0.708 1.917,0.875 true 1.594,0.469 1.26,0.469 true 1.083,0.375 1.396,0.531 0.313,0.156 10 false *a 1.854,0.885 2.167,1.042 0.313,0.156 10 false *b 2.104,1.042 2.417,1.198 0.313,0.156 10 false *c 2.792,1.104 3.104,1.26 0.313,0.156 10 false *d 1,0.771 1.313,0.927 0.313,0.156 10 false *e 1.781,1.292 2.094,1.448 0.313,0.156 10 false *f
*a to front wheel LH
*b to rear wheel RH
*c to rear wheel LH
*d to front wheel RH
*e from master cylinder FL-RR
*f from master cylinder FR-RL


Place tags or marks to identify the installation locations of each brake line.


d.
C332230

Remove the 3 bolts and brake actuator with bracket.


Hide 44510 3.REMOVE BRAKE ACTUATOR ASSEMBLY

a.

Using a 6 mm hexagon wrench, remove the 3 hexagon bolts and the brake actuator assembly.


Hide 44547B 4.REMOVE BRAKE ACTUATOR BRACKET CUSHION

a.

Remove the 3 brake actuator bracket cushions.