Release the vacuum from booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from brake booster.
1.DRAIN BRAKE FLUID
Immediately wash off any brake fluid that comes into contact with any painted surface.
31481A
2.DISCONNECT NO. 1 CLUTCH RESERVOIR HOSE (for 2NR-VE with Manual Transmission)
Slide the clip and disconnect the No. 1 clutch reservoir hose.
47201
3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
Disengage the clamp and disconnect the brake fluid level warning switch connector.
Using a 10 mm union nut wrench, separate the 2 brake tubes from the brake master cylinder sub-assembly.
Disengage the 2 clamps and separate the 2 brale tubes from the body.
Remove the 2 nuts and remove the brake master cylinder sub-assembly.
Remove the O-ring from the brake master cylinder sub-assembly.
The master cylinder sub-assembly requires careful handling. Do not allow the master cylinder sub-assembly to receive any impact, such as from being dropped. Do not reuse a master cylinder sub-assembly that has been dropped.
Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.
Release the vacuum from booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from brake booster.
When installing the brake master cylinder sub-assembly onto the brake booster, or when removing the brake master cylinder sub-assembly from the brake booster, make sure that the brake master cylinder sub-assembly is kept horizontal or its tip faces downward (the piston faces upward) to prevent the master cylinder piston from falling off.
Do not allow any foreign objects to contaminate the master cylinder piston. If a foreign object gets on the piston, remove it by using a piece of cloth and then apply an even layer of lithium soap based glycol grease around the circumference (sliding part) of the piston.
Do not use any other type of grease or fluid.