FAIL-SAFE FUNCTION
When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate. The fail-safe function that is specified for each system operates to prevent those systems from malfunctioning.
The following table shows the effects on each system when communication is impossible. (For further details, see the pages for each system.)
| Function | Control Master | System Related | Fail-safe Operation | Driver Detectable | DTC Detection
(ECU that stored DTC) |
|---|---|---|---|---|---|
| Automatic Transmission* | TCM (ECM) | ECM | When trouble is detected, shift into 3rd and then shift into the 1st to 3rd depending on the vehicle speed. | - | U0100
(TCM (ECM)) |
| Speedometer
(Speedometer display for vehicle speed signal from TCM (ECM)* or skid control ECU (brake actuator assembly).) |
Combination meter assembly | ·
TCM (ECM)* ·
Skid control ECU (brake actuator assembly) |
Signal is treated as 0. | Vehicle speed on the meter is indicated as 0 km/h. | U0101*
U0129 (Combination meter assembly) |
| ODO/TRIP meter
(ODO/TRIP display for vehicle speed signal from TCM (ECM)* or skid control ECU (brake actuator assembly).) |
Combination meter assembly | ·
TCM (ECM)* ·
Skid control ECU (brake actuator assembly) |
Stops calculation and continues the last display. | - | U0101*
U0129 (Combination meter assembly) |
| Tachometer
(Tachometer display for engine speed signal from ECM.) |
Combination meter assembly | ECM | Signal is treated as 0. | Engine speed on the meter is indicated as 0 rpm. | U0100
(Combination meter assembly) |
| Telltale
(Controls indicator illumination and blinking according to various signals.) |
Combination meter assembly | ·
ECM ·
TCM (ECM)* ·
Skid control ECU (brake actuator assembly) ·
Power steering ECU assembly ·
Main body ECU (fuse block assembly) ·
Airbag ECU assembly |
Lights do not illuminate or lights remain illuminated. | ·
MIL comes on. ·
BRAKE warning light comes on. ·
ABS warning light comes on. ·
EPS warning light comes on. ·
SRS warning light comes on. |
U0073
U0100 U0101* U0129 U0131 U0142 U0151 (Combination meter assembly) |
| Buzzer
(Controls sounding of buzzer for various functions.) |
Combination meter assembly | ·
ECM ·
TCM (ECM)* ·
Skid control ECU (brake actuator assembly) ·
Main body ECU (fuse block assembly) ·
Airbag ECU assembly |
Buzzer stops sounding or does not sound. | - | U0073
U0100 U0101* U0129 U0142 U0151 (Combination meter assembly) |
| Power steering ECU assembly | EPS buzzer sounds intermittently for 6 seconds. | EPS buzzer sounds intermittently for 6 seconds. | U0131
(Combination meter assembly) |
||
| Electronic power steering
(Changes steering assistant power in accordance with vehicle speed.) |
Power steering ECU assembly | ·
ECM ·
Combination meter assembly |
Since vehicle speed cannot be detected, control continues under the assumption speed. | - | U0100
U0155 (Power steering ECU assembly) |
| Headlight | Main body ECU (fuse block assembly) | Combination switch ECU (switch base) | When trouble is detected with ignition switch ON, low beam headlights illuminate. | - | U0073
U1000 U1112 (Main body ECU (fuse block assembly)) |
| Front wiper | Main body ECU (fuse block assembly) | Combination switch ECU (switch base) | When trouble is detected, front wipers only operate in high position. | - | U0073
U1000 U1112 (Main body ECU (fuse block assembly)) |
*: for Automatic Transmission