Home › Vehicle Interior › SEAT › REAR NO. 1 SEAT ASSEMBLY › from 2015.08
RM19Y0E _58 Vehicle Interior _003011 SEAT _0015215 REAR NO. 1 SEAT ASSEMBLY A

SEAT  REAR NO. 1 SEAT ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp surfaces on the rear seatback frame sub-assembly and rear seat cushion spring assembly could cause injuries to your hands.


HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 72637A 1.REMOVE REAR SEAT LOCK HANDLE

a.
B292423C02
0.698,1.5 1.344,1.385 true 1.594,1.198 2.479,1.396 true 0.521,1.417 0.938,1.74 0.417,0.323 10 *2 2.542,1.333 2.927,1.667 0.385,0.333 10 *1
*1 Protective Tape
*2 Snap Ring


Using a screwdriver with its tip wrapped in protective tape, pull out the snap ring and remove the rear seat lock handle.


Hide 71833D 2.REMOVE REAR SEAT RECLINING COVER

a.
B411985

Remove the screw.


b.

Disengage the 2 claws to remove the rear seat reclining cover.


Hide 79011 3.REMOVE NO. 1 SEAT CUSHION COVER SUB-ASSEMBLY

a.
B411986

Remove the 2 screws.


b.

Disengage the 4 claws to remove the No. 1 seat cushion cover sub-assembly.


Hide 4.REMOVE REAR NO. 1 SEATBACK ASSEMBLY

a.
B411987C01
2.438,1.458 2.052,1.156 true 1.896,1.052 2.094,1.219 0.198,0.167 10 false *1
*1 Rear Seat Lock Control Cable


Disengage the clamp and disconnect the rear seat lock control cable.


b.

Remove the 4 bolts and rear No. 1 seatback assembly.


Hide 71878A 5.REMOVE REAR SEAT INNER RECLINING COVER

a.
B411988

Disengage the 2 claws to remove the rear seat inner reclining cover.


Hide 71956B 6.REMOVE REAR SEAT HEADREST SUPPORT ASSEMBLY

a.
B411989C01
1.229,0.823 0.875,0.208 0.875,0.208 2.458,0.594 true 0.677,0.115 0.99,0.271 0.313,0.156 10 false *1
*1 Fastener


Detach the hook and open the fastener.


b.
B296110

Disengage the 2 claws to remove the rear seat headrest support assembly.

HINT:

Use the same procedure as for all rear seat headrest support assemblies.



Hide 71956B 7.REMOVE REAR SEAT HEADREST SUPPORT

a.
B296113

Disengage the 2 claws to remove the rear seat headrest support.

HINT:

Use the same procedure as for all rear seat headrest supports.



Hide 71077S 8.REMOVE SEPARATE TYPE REAR SEATBACK COVER

a.
B411990

Remove the 13 hog rings and separate type rear seatback cover from the separate type rear seatback pad.


Hide 71651S 9.REMOVE SEPARATE TYPE REAR SEATBACK PAD

a.
B411991

Remove the separate type rear seatback pad from the rear seatback frame sub-assembly.


Hide 71671A 10.REMOVE REAR SEATBACK SILENCER PAD A

a.
B292433

Remove the rear seatback silencer pad A from the separate type rear seatback pad.


Hide 72159A 11.REMOVE REAR SEAT TRACK BRACKET COVER

a.
B411992

Disengage the 2 claws to remove the rear seat track bracket cover.

HINT:

Use the same procedure for the other rear seat track bracket covers.



Hide 72995 12.REMOVE REAR SEAT CUSHION COVER

a.
B364870

Remove the 4 screws and rear seat cushion cover.


Hide 73330C 13.REMOVE REAR SEAT LAP TYPE CENTER BELT ASSEMBLY

Hide 72670B 14.REMOVE REAR SEAT CUSHION LOCK ASSEMBLY

a.
B411994C01
1.74,1.875 1.594,1.219 true 1.688,1.927 1.854,2.083 0.167,0.156 10 false *1
*1 Rear Seat Lock Control Cable


Disengage the clamp and disconnect the rear seat lock control cable.


b.

Remove the 2 bolts and rear seat cushion lock assembly.


Hide 72670B 15.REMOVE REAR SEAT OUTER CUSHION LOCK ASSEMBLY

a.
B411995C01
1.677,1.885 2.042,1.5 true 1.521,1.896 1.698,2.094 0.177,0.198 10 false *1
*1 Rear Seat Lock Control Cable


Disengage the clamp and disconnect the rear seat lock control cable.


b.

Remove the 2 bolts and rear seat outer cushion lock assembly.


Hide 71308E 16.REMOVE REAR SEAT LEG SUB-ASSEMBLY

a.
B377708

Remove the 6 nuts and rear seat leg sub-assembly.


Hide 72160C 17.REMOVE REAR NO. 1 SEAT OUTER TRACK ASSEMBLY

a.
B411996

Remove the 2 bolts and rear No. 1 seat outer track assembly.


b.
B411997

Slide the coil spring in the direction of the arrow, and then release the hook of the seat track equalizing wire sub-assembly from the rear No. 1 seat outer track assembly.


Hide 72170C 18.REMOVE REAR NO. 1 SEAT INNER TRACK ASSEMBLY

HINT:

Use the same procedure as for the rear No. 1 seat outer track assembly.


Hide 72695A 19.REMOVE REAR SEAT LOCK CONTROL CABLE

a.
B411998C01
2.25,1.885 3.063,1.219 3.063,1.219 2.323,0.271 true 3.135,1.156 3.354,1.354 0.219,0.198 10 false *1
*1 Fastener


Open the fastener.


b.
B411999C01
2.167,2.115 1.344,3.146 1.344,3.146 1.698,1.729 true 2.281,1.417 2.594,0.531 true 1.26,3.198 1.573,3.354 0.313,0.156 10 false *1 2.563,0.344 2.875,0.5 0.313,0.156 10 false *1
*1 Band


Cut the 3 bands to remove the rear seat lock control cable.


Hide 71075D 20.REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER

a.
B363921

Remove the 9 hog rings.


b.
B363922

Remove the 14 hog rings and separate type rear seat cushion cover from the rear seat cushion pad.


Hide 71611A 21.REMOVE REAR SEAT CUSHION PAD

a.
B412000

Remove the rear seat cushion pad from the rear seat cushion spring assembly.


Hide 71621A 22.REMOVE REAR SEAT CUSHION SILENCER PAD

a.
B292447

Remove the rear seat cushion silencer pad from the rear seat cushion pad.