88550B
1.REMOVE BLOWER MOTOR ASSEMBLY
87138C
2.REMOVE BLOWER RESISTOR
88515
3.REMOVE COOLER EXPANSION VALVE
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and detach the cooler expansion valve.
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
Use the same procedure for the RHD and LHD vehicles.
88578B
4.REMOVE COOLER UNIT CASE PACKING
Remove the cooler unit case packing.
Use the same procedure for the RHD and LHD vehicles.
5.REMOVE AIR FILTER CASE (for LHD)
Remove the 2 screws.
Disengage the 4 claws to remove the air filter case.
6.REMOVE AIR FILTER CASE (for RHD)
Remove the 2 screws.
Disengage the 5 claws to remove the air filter case.
88501
7.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY (for RHD)
w/o Heater:
Disengage the No. 1 cooler thermistor connector clamp.
Remove the 7 screws.
Remove the 7 screws.
Disengage each claw to remove the upper case.
Remove the No. 1 cooler evaporator sub-assembly.
w/ Heater:
Disengage the No. 1 cooler thermistor connector clamp.
Remove the 24 screws.
Remove the blower case.
Remove the upper case.
Remove the No. 1 cooler evaporator sub-assembly.
88501
8.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY (for LHD)
Disengage the No. 1 cooler thermistor connector clamp.
Remove the 28 screws.
Remove the blower case.
Remove the upper case.
Remove the No. 1 cooler evaporator sub-assembly.
88625
9.REMOVE NO. 1 COOLER THERMISTOR
87107A
10.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY (w/ Heater)
Remove the screw.
Remove the heater radiator unit sub-assembly.
Use the same procedure for the RHD and LHD vehicles.