Use the same procedure for the RHD and LHD vehicles.
88410
1.REMOVE MAGNET CLUTCH ASSEMBLY
Disengage the connector clamp.
Clamp the cooler compressor assembly between aluminum plates in a vise.
Using SST, hold the magnet clutch hub.
Remove the bolt, magnet clutch hub and magnet clutch washer(s).
There is no set number of magnet clutch washers since they are used for adjusting.
Using a snap ring expander, remove the snap ring and magnet clutch rotor.
Do not damage the seal cover of the bearing when removing the snap ring.
Using a snap ring expander, remove the snap ring and magnet clutch stator.