Use the same procedure for the RHD and LHD vehicles.
88320
1.INSPECT COOLER COMPRESSOR ASSEMBLY
Check the operation.
Start the engine.
Inspect the compressor pulley.
Compressor shaft rotates along with pulley.
| *a | Component without harness connected
(Magnet Clutch Assembly) |
Inspect the cooler compressor.
Disconnect the connector.
Apply battery voltage to the clutch and check the operation of the clutch.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1
Battery negative (-) → Body ground |
Magnet clutch is engaged |
If the result is not as specified, replace the compressor.